Configuring the Parameter Variation

AnyLogic supports two modes of varying parameters:

You may vary only the parameters of the top-level agent. If you want to vary the parameters of encapsulated objects, you should use parameter propagation.

 To configure parameter variation
  1. Select the parameter variation experiment in the Projects view. 
  2. Go to the Parameters section of the Properties view.
  3. Select, whether you want parameters to be Varied in range or Freeform varied. If you choose Freeform, specify how many times this experiment will run the model in the Number of runs edit box below. 
  4. Parameters to vary are defined in the Parameters table. This table lists all parameters of the top level agent. Each parameter is defined in the individual table row.